Hindu Religious And Charitable Endowments Joint Commissioner Office Erode Arulmigu Velayuthasamy Temple Thindal Tender

Supplying and fixing in position of 16mm dia Mild Steel or R.T.S. rod inside the drilled holes including cost of steel, charges for cutting, fixing with cement slurry grouting, curing etc., complete complying with standard specifications and as directed by the Engineer in charge of the work.

Plain cement concrete 1:4:8mix (one part of cement,Four parts of sand and eight parts of 40 mm hard blue granite metal by volume) for leveling course in foundation bailing out water if necessary, ramming, consoli dating, curing etc., cost and conveyance of all materials complete in all respects complying with the relevant standard specifications, including at all leads & depths inside the building.

Supplying and erecting steel shuttering including necessaray supports for plane surfaces in foundation and basement for Reinforced Cement Concrete works such as column footings,plinth beam, grade beam,staircase steps, bed blocks etc., which requires only nominal strutting using stiffened with mild steel sheets of size 90x60cm BG 10 stiffened with mild steel angle of size 25x25x3mm for boarding laid over silver oak joist of size 10x6.50cm spaced at above 60cm c/c and supported by the casurina props of 10cm to 13cm dia spaced at 75cm c/c at suitable intervals etc., complete complying with standard specifications.

Supplying and Erecting, Centering for sides and soffits including supports and strutting upto 3.29m height for plane surfaces as detailed below in all floors with all cross bracings using mild steel sheets of size 90cm X 60cm and BG 10 gauge stiffened with welded mild steel angles of size 25mm X 25mm X 3mm for boarding laid over silver oak joists of size 10cm X 7.50cm spaced at about 90cm centre to centre and supported by Casurina props of 10cm to 13cm dia spaced at not less than 75cm centre to centre at sutiable intervals etc., complete in all floors for complying with standard specifications.

Plane surfaces such as RCC floor slab, roof slab, rectangular, square, Tee or Ell beam, lintels, bed blocks staircase waist slab, landing slab, landing beams, portico beams, portico slab etc.,

From Ht 0-19.80M

Plane surface such as RCC square or rectangular columns, top and bottom slab of sunshade, boxing sill slabs, etc.,

From Ht 0-19.80M

Providing additional strutting to centering of RCC item of plain surfaces for every additional 1m height or part there of but not less than 30cm over the initial 3.29m height from floor level using casurina props of 10cm to 13cm dia including cross bracing etc., complete complying with standard specfication and as directed by the Departmental officers.

From Ht 3.30-19.80M

Providing and laying in position, standardised Reinforced cement concrete Mix M-25 Grade(Design mix) in accordance with IS:456-2000, using 20mm and down graded hard broken granite stone jelly for all RCC items of works with minimum cement content of 350 kg/m3 and maximum water cement ratio of 0.55, including admixture (plasticiser / super plasticiser) in recommended proportions as per IS:9103 to accelerate, retard setting of concrete, improve workability without impairing strength and durability with about (5 cu.m.) 7730 kg. of 20mm machine crushed stone jelly and with above (3.3 cu.m.) 5156 kg. of 10-12mm machine crushed stone jelly and with about (4.79 cu.m.) 7670 kg. of sand, but excluding cost of reinforcement grill and fabricating charges, centering and shuttering and also including laying, vibrating with mechanical vibrators, finishing, curing,etc., complete complying with standard specification and as directed by the departmental officers.

Foundation Footing

Above Grround Level Up to 3.30m

From 3.30-6.60m ht

From 6.60-9.90 m ht

From 9.90-13.20m ht

From 13.20-16.50m ht

From 16.50-19.80

Supplying, fabricating and placing in position Mild steel or Ribbed tor steel reinforcement grill for RCC works as per the design given including cost of steel and black binding wire in all floors etc., complete complying with standard specifications. (The contratctor will have to make his own arrangements for the supply of MS plain rod / RTS rod and black binding wire)

Manufacturing, Supplying and Fixing of Stainless Steel Hand rails for outer all around temple using 50mm dia 304L Grade Stainless Steel pipe of 1.60mm thick at required locations to a height of 900mm from finished floor level welded to 38mm dia Stainless Steel pipe post of 1.00mm thick as vertical at 900mm centre with 2 Nos. of 25mm dia intermediate horizontal stainless steel pipe of 1.60mm thick in between. The vertical pipe has to be welded to the 100 X 100 X 6mm MS base plate encased in the base concrete. The rate is inclusive of the charges for cutting, bending, welding,grinding, polishing, conveyance, electrical charges, etc.complete.

Paving the floor with best approved quality Granite Stone Slabs of size 1200 x 600 of 18 / 20mm thick of Synthetic Grey, Paradise and similar varieties with machine cut edges laid over a cement mortar bed of 20mm thick using cement mortar 1:3 (One cement and three sand) fixing the slabs with required cement slurry and laid in true right angles with minimum possible width of joints and pointing the joints with white cement mixed with mathcing colouring pigments etc., The granite stone slabs and other materials to be used shall be got approved by the Executive Engineer concerned before use on work, etc., complete as per standard speicification.

Special ceiling plastering and finishing the exposed surface of all RCC items of work such as slabs, beams, sunshades, facia, canopy slab, staircase waist slab, landing slab etc., with Cement Mortar 1:3 (One Cement and Three Sand) 10mm thick including hacking the surfaces, providing cement mortar nosing, beading for sunshades, staircases, steps, landing slabs and curing, etc., in all floors complying with standard specification and as directed by the departmental officers.

White washing two coats with freshly burnt white shell lime in all floors including cost of lime, blue powder fevicol type gum, brushes, scaffolding charges, etc., complete complying with standard specification and as directed.

Painting the wall two coats with approved weather proof Exterior Emulsion paint over one primer coat of over cement plastered wall surface etc., complete complying with standard specification.

Weathering course in brick jelly lime concrete using broken brick jelly of size 20mm uniform gauge in pure slaked lime (no sand to be used) to the proportion of brick jelly to lime being 32:12.5 by volume and laid over the RCC roof slab in a single layer of required slope and finished by beating the concrete with wooden beaters of approved pattern, keeping the surface constantly wet by sprinkling lime jaggery water, etc., complete as per standard specification and as directed by the deparmental officers.

Finishing the top of roof with one course of machine pressed tiles of size 230mm x 230mm x 18mm of approved quality set in Cement Mortar 1:3 (One Cement and Three Sand) 12mm thick mixed with water proofing compound conforming to ISS at 2% by weight of cement used and the joints pointed neatly to full depth of tiles with the same cement mortar mixed with red oxide and water proofing compound including curing etc., complete complying with standard specification and as directed by the departmental officers

Supplying and fixing Best Quality Mangalore Ridge Tiles (I class A) over best Quality pressed tiles 230x230x23mm The cost includes cost of all materials, scaffolding charges, etc complete. complete as per standard speicification. and as directed by the departmental officers

Providing double nosing of Granite slab for steps and side wall area complete. complete as per standard speicification. and as directed by the departmental officers

GST Amount for providing Service to Government Contract Works for the above works at 18%(9%+9%). {GST Amount is the Total GST Amount for overall quoted amount}