The Orissa State Cooperative Milk Producers Federation Limited Tender

Filling selected excavated earth other than plinth, by mechanical / manual means for land development etc., to required level, within the site (Lead not exceeding 300m) in layers of 15cm to 20cm including watering, consolidating, ramming and compacting etc. complete as directed including cost of excavation, loading, unloading and transportation, T&P, complete as per direction of Engineer-in-charge.

Providing, supplying and filling approved local sand by mechanical / manual means for land development etc., in low land area, foundation, trenches, & plinth foundation areas, and foundation surrounding areas in layers of 150mm to 200mm including watering, ramming and consolidating, transportation, freight, loading, unloading, labour, T&P, taxes, octori, levies, royalties, spreading and compacting etc. complete as per direction of Engineer-in-charge.

Providing, supplying & laying in position machine mixed plain cement concrete in volumetric proportion (1:3:6) of any thickness for volumetric proportion 1: 3: 6 (1cement: 3 coarse sand: 6 HG stone crusher broken stone aggregates of size 37mm and down) in required thickness, for foundations, below walls, hard park, column footings, sunk floor, terraces, rafts, roads at any height above plinth level, at any depth below floors, plinth protection, etc.excluding centering and shuttering, if required, laying, spreading, ramming, consolidating, as per requirement and curing etc. including cost of all materials, transportation, loading, unloading, labour, T&P, taxes, duties, levies, octori, royalties etc. complete as per direction of Engineer- in-charge.

Providing, supplying & laying in position machine mixed and machine vibrated cement concrete of controlled grades of specified volumetric proportions, for reinforcement cement concrete structural elements, viz. foundation, columns, beams, slabs, precast slab, raft, floor, plinth beam, window sills, coping, walls, parapet, drops, fins, boxes, gutters, folded plates, chajhas, overhead and under ground water tanks, culverts etc. at different levels in any shape as per structural design and as directed in specified compressive strength expressed in N/sqmm at 28 days as per I.S: 456-1978 using 20mm and down size of hard crusher broken black granite aggregates, necessary lift and lead finishing concrete surfaces, and for M-20 or volumetric proportion 1:1 1/2: 3 (1 cement : 1 1/2 : coarse sand: 3 HG stone aggregates of size 20mm ) and down concrete in ground and plinth etc. excluding cost of centering and shuttering / centering & reinforcement and including cost of all material but excluding cost of reinforcement and including cost of curing, transportation, loading, unloading, of all materials and labour, T&P, taxes, duties, levies, octori, royalties etc. complete

Providing, supplying & fixing plywood shuttering for any shape and size as specified in Architect's Drawing including rigid & smooth shuttering centering, bracing & propping, housing, keeping the same in position, providing access, and removal of the same after specified period, cost of all material, carpentry works, nails, including laying of polytheen over the shuttering and including cost of transportation, loading, unloading, of all materials and labour, T&P, taxes, duties, levies, octori, royalties etc. complete as per direction of Engineer –In-Charge.

Providing, supplying & laying in position machine mixed and machine vibrated cement concrete of controlled grades of specified volumetric proportions, for reinforcement cement concrete structural elements, viz. foundation, columns, beams, slabs, precast slab, raft, floor, plinth beam, window sills, coping, walls, parapet, drops, fins, boxes, gutters, folded plates, chajhas, overhead and under ground water tanks, culverts etc. at different levels in any shape as per structural design and as directed in specified compressive strength expressed in N/sqmm at 28 days as per I.S: 456-1978 using 20mm and down size of hard crusher broken black granite aggregates, necessary lift and lead finishing concrete surfaces, and for M-20 or volumetric proportion 1:1 1/2: 3 (1 cement : 1 1/2 : coarse sand: 3 HG stone aggregates of size 20mm ) and down concrete in ground and plinth etc. excluding cost of centering and shuttering / centering & reinforcement and including cost of all material but excluding cost of reinforcement and including cost of curing, transportation, loading, unloading, of all materials and labour, T&P, taxes, duties, levies, octori, royalties etc. complete

Providing, fabricating and fixing in position steel reinforcement for RCC structural elements, viz. foundation, columns, beams, slabs, precast slab, raft, floor, plinth beam, window sills, coping, walls, parapet, drops, fins, boxes, gutters, folded plates, chajhas, mullions, overhead and under ground water tanks, road pavement, kerbs, culverts, etc. at different levels in any shape as per structural design and drawing and as directed and specified, as per design at all levels including lift and loading, unloading & transporting steel within site premises from departmental store to the work site, unloading and incidental charges for handling, cutting, bending and binding at all height and floor with 16 gauge GI wire (to be supplied by the contractor at his own cost), welding if necessary etc., labour, T&P complete as per direction of Engineer-in-charge.

Providing, supplying and constructing brick masonry in CM 1:6 (1 cement: 6 coarse sand) in foundation and upto roof level with 1st class quality approved fly ash bricks having minimum crushing strength 70kg/sqcm including all necessary scaffolding, racking out the joints, including cost of all materials, transportation, curing, loading, unloading, labour, T&P taxes, duties, levies, octroi royalties etc. complete as per direction of Engineer in-charge.

Providing, supplying and laying Vacuum Dewatered Flooring (VDF) of Tying Line Dori (Threads) as per the slope requirements. Laying Guide Rails to every 4 meters using MS Channels or as required in straight lines along the Line Dori, taking levels as per the slope and fixing them using concrete also called grouting and left to set for a minimum of 24 hours. Pouring the concrete in between the channels and spreading using Shovel or Hoe (Kudal/Parah). Vibrating the concrete with a poker vibrator especially to the sides of the panels. Surface Vibration the concrete using Double Beam Screed Vibrator running over the guide rails twice to achieve maximum compaction for RCC with double mats. Final levelling of the concrete using the Straight Edge/Bull Float/Aluminium Bottom (Fanti/Baddha).A system of lower mats & top mat is laid on the green concrete & this is attached to a vacuum pump. This draws out surplus water if any. (We strongly oppose dewatering of RMCs. RMCs have water cement ratio already maintained to its minimum possible level by addition of admixtures. Further dewatering decreases the water cement ratio below the required level thereby causing undulations in the surface, loss in strength and formation of cracks.). The concrete is left to stiffen. When the base concrete has stiffened to the point when foot traffic leaves an imprint of about 3-6 mm and any bleed water should now have evaporated, but the concrete should have a wet sheen, Floor Hardener is applied at an even application rate of 3-7 Kg/Sqm or as per the requirement of the floor. Application of Power Floater on the surface until the surface is sufficiently compacted & levelled with no major lines appearing any more. Final finishing using Power Trowel and trowelling until the required finish is achieved. Finish could be any of the Smooth Finish, Sand Finish or Line Finish.

Providing, supplying and laying 10 mm thick Chequre tile flooring” of solid, grade thickness 75mm,of Italia Brand Primium Quality with top polished with epoxy paints of 6 Micron of size surface leveled dressed size in floors and Paving , at all height above plinth. The tile should be laid over 200 mm avarge thick of sand and earth of proportion 1:1 as specifications, 50 mm joint between the tile should be maintained deep and the same should be filled with grass, including cost of all materials, transportation, loading, unloading, labour, T&P, taxes, duties, levies, octroi, royalties, etc. complete as per direction of Engineer in-charge.

Providing, supplying and applying 12mm thick cement plaster in line and level, at all heights above and below plinth level with cement motar 1:4 (1 cement: 4 sand) to walls, beams, ceiling, stair, column, pardis, bends, moulds, pattas, grooves, etc. including scaffolding, curing, finishing smooth (the plaster surface shall be troweled till the surface shows cement paste), and chipping the concrete at all levels including cost of all materials, transportation, lift, loading, unloading, curing, labour, tools and plants, taxes, duties, levies, octroi, royalties etc. complete as per direction of Engineer – In-Charge

Providing, supplying & applying two coats of plastic emulsion paints (Water based ) of approved make and shade of reputed make and finished smooth and even surface to receive painting including cost of scaffolding staging charges on smooth plaster finished surfaces of walls, beams, ceiling, stair, column, pardis, bends, moulds, pattas, grooves etc. at all heights above plinth level and preparation of surface for painting, scaffolding, curing etc., including cost of all materials, transportation, loading, unloading, labour, T&P, taxes, duties levies, octroi, royalties etc. complete as per direction of Engineer - In-Charge

Providing, supplying, fabricating hoisting and fixing in position M.S. structure fabricated with M.S. channels, angle, flat, joist structure/Truss protection channels of reception dock, Runner & Purloin for laying Asbestos sheet provision etc. as per architectural drawing and design including cutting, electrical arc welding, grinding to smooth surface at all level for GI sheet roofing, drilling holes, welding tie with required GI ‘L’ hooks, nuts, washers & tar washers etc. and grouting with P.C.C. (1:1 ½:3 or M-20) as per design including 2 coats of first quality synthetic enamel paint of make Asian or equivalent all complete. including cost of all materials, transportation, loading, unloading, labour, tools & paints, taxes, duties, levies, lift, octroi, royalties etc. complete as per direction of Engineer-in-Charge.

Providing, supplying and fixing in position in line and level Galvanised Meta sheets of 18 gauge in Roofing of reputed brand at all level on, or above the of the M.S. structure with required rust proof GI hooks, screw, nuts, washers & tar washers etc. level including cost of all materials, transportation, loading, unloading, lift, labour T&P taxes, duties, levies, octori, royalties etc. completed as per direction of Engineer-in-charge.

Supplying, fitting and fixing of M.S shutter with frame with M.S angle frame of 35x35x6 mm and shutter section 30x30x5 mm M.S angle with welding of 25x25x6 mm flat and welding of 16 gauge C.R sheet with arrangement of clamp, fitting of 3 nos of 4" hinges, 1 no of 2" hinges and 300 mm x 16mm M.S aldrop with 8" tower bolt including cost , conveyance, taxes of all materials , labour , T& P etc. required for the complete in all respect.

A Light Point wiring with 2.5 sq.mm. PVC insulated Copper conductor 650V grade wires in 25 mm dia 16 SWG surface/concealed conduit system including providing and fixing one no. 6 Amp. Single pole piano key switch in M.S. box with 3mm thick hylem sheet cover complete with 2.5 sq.mm. Circuit for one light pint controlled by one switch.

Circuit wiring with PVC insulated 650V grade, Copper conductor wire for power and green PVC insulated copper conductor for earthing in 16 SWG surface/concealed conduit system, complete with MS draw out boxes and cover, wires and conduit sizes as given below: 2 x 2.5 sq.mm. for power and 1x1.0sq.mm. for earthing in 25mm dia conduit (from BDB to individual switch board)

Supply, installation, testing and commissioning of company made distribution board of approved make and making good to all damages caused and inter connection with 2.5 sq.mm. Copper wire and complete with all respect fixing in the wall. Light distribution board , Incoming: 8A DP MCB : 01 Nos. Outgoing: 8A SP MCB : 2nos. Incoming: 8A DP MCB : 01 Nos. Outgoing: 8A SP MCB : 2nos.

Supply of standard modular LED lamp 20 watt each make Philips /Bajaj

Supply , fitting , fixing of internal electrification item as per requirement of site. including cost of all materials, transportation, loading, unloading, labour, T&P taxes, duties, levies, octroi etc. complete as per direction of Engineer in-charge.