Rural Development Department Tender

Item No. 3 :- Removing doors and windows with frames and stacking the materials as directed with all leads, lifts etc. complete. [As directed by Engineer in charge.] (S.S.R. I.No. 46.15)

Item No. 4 :- Providing soling using 80 mm size trap metal in 15 cm. layer including filling voids with Crushed sand/grit, ramming, watering etc. complete. [Spec.No. : As directed by Engineer incharge.] (S.S.R. I.No. 21.4 P.No. 152 )

Item No. 5 :- Providing and laying Cast in situ/Ready Mix cement concrete in M-10 of trap/ granite/ quartzite/ gneiss metal for foundation & bedding including bailing out water Steel centering formwork laying/pumping, compacting, roughening them if special finish is to be provided, finishing if required & curing complete, with fully automatic micro processor based PLC with SCADA enabled reversible Drum Type mixer/concrete Batch mix plant (Pan mixer) etc. complete With fine aggregate (Natural Sand / Crushed sand VSI Grade finely washed etc) [Bd.E.1 P.No. 287] (S.S.R.I.No. 24.01 P.No. 169)

Item No. 6 :- Providing and laying vitrified mirror / glossy finish tiles decorative type having size 590 mm to 605 mm x 590 mm to 605 mm of 8 to 10 mm thickness and confirming to IS. 15622-2006 ( group Bla) of approved make, shade and pattern for flooring in required position laid on a bed of 1:4 cement mortar including neat cement float, filling joints, curing and clearing etc. complete. a) Flooring [Bd.M. 12 Page No.385] (S.S.R. I.No. 33.40)

Item No. 7 :- Providing and laying vitrified mirror / glossy finish tiles having size 590 mm to 605 mm x 590 mm to 605 mm of 8 to 10 mm thickness and confirming to IS. 15622-2006 ( group Bla) of approved make, shade and pattern for flooring in required position laid on a bed of 1:4 cement mortar including neat cement float, filling joints, curing and clearing etc. complete.b) Skirting [Bd.M. 12 Page No.385] (S.S.R. I.No. 33.41)

Item No. 8 :- Providing and laying ceramic tiles of having size 30 cm x 30 cm confirming to I.S.15622/2006 (group D II-A) and 7 to 8 mm thick for flooring in required position laid on a bed of 1:4 cement mortar including cement float, filling joint with white/colour cement slurry cleaning curing etc complete. [Bd.M.12 P.No 385] (S.S.R.I.No. 33.24)

Item No. 9 :- Providing and laying ceramic tiles of having size 30 cm. x 30 cm. and confirming to corresponding I.S. for dado and skirting in required position with readymade adhesive mortar of approved quality on plaster of 1:2 cement mortar including joint filling with white/ colour cement slurry cleaning curing etc. complete. [Bd.M.13 Page No. 386.] (S.S.R.I.No. 33.25 P.No. 207)

Item No. 10 :- Providing internal cement plaster 12mm thick in single coat in cement mortar 1:4 without neeru finish to concrete or brick surfaces, in all positions including scaffolding and curing etc. complete. [Bd. L.2 P.No. 368] (S.S.R. I.No. 32.04 P.No. 201)

Item No. 11 :- Providing and applying Two coats of wall care Putty on plastered surface and Ceiling and Walls to prepare surface even and smooth of approved make, etc complete. [Bd.L.1 P.No. 367 ] (C.S.R.I.No. 32.34 P.No. 203)

Item No. 12 :- Providing rough cast cement plaster externally in two coats to concrete, brick or stone masonry surfaces in all positions with base coat of 12 to 15 mm thick in C.M. 1:4 and rough cast treatment 12mm thick in proportion 1:1 1/2:3 including scaffolding and fourteen days curing complete. [Bd.L.8 P.No. 370] (S.S.R. I.No. 32.12)

Item No. 13 :-Providing and laying damp proof course 50 mm thick in M20 cement concrete layer and bitumen / using cement with waterproofing compound curing, formwork etc. complete. [Bd.J.2 Page No. 355] (S.S.R.I.No. 31.01)

Item No. 14 :- Providing and fixing solid core flush door shutter in single leaf 32 mm thick decorative type of exterior grade as per detailed drawings approved face veneers 3 mm thick on both faces or as directed, all necessary beads, mouldings and lipping, wrought iron hold fasts, chromium plated fixtures and fastenings, with brass mortise lock, chromium plated handles on both sides, and finishing with French Polish etc. complete. (C.S.R.I.No. 39.09 P.No. 236)

Item No. 15 :- Providing and fixing in position. (as per I.S.1868 / 1982) Aluminium sliding window of two tracks with rectangular pipe having overall dimension 63.50 x 38.10 x 1.02 mm at weight 0.547 kg/Rmt. and window frame bottom track section 61.85 x 31.75 x 1.20 mm at weight 0.695 kg/Rmt. Top and side track section 61.85 x 31.75 x 1.30 mm at weight 0.659 kg/Rmt. The shutter should be of bearing bottom 40 x 18 x 1.25 mm at weight 0.417 kg/Rmt. Inter locking section 40 x 18 x 1.10 mm at weight 0.469 kg/Rmt. And handle section 40 x 18 x 1.25 mm at weight 0.417 kg/Rmt. and top section 40 x 18 x 1.25 mm at weight 0.417 kg/Rmt. As per detailed drawings and as directed by Engineer in charge with all necessary Aluminium sections fixtures and fastenings such as roller bearing in nylon casting and self locking catch fitted in vertical section of shutter including 5 mm thick plain glass with all required screws & nuts etc, complete. With colour Anodising with box. [As directed by Engineer in charge.] (S.S.R.I.No. 39.37)

Item No. 16 :- Providing and fixing fiber glass reinforced polyster door shutter 30 mm thick as per IS 14856 (2000) (Reaffirmed 2006) without ventilator including chromium plated fixtures and fastening with chromium plated handles on both sides, etc complete [As directed by Engineer in charge.] (C.S.R.I.No. 39.58 Page No. 246)

Item No. 17 :- Providing and applying priming coat on concrete/ masonary/ Asbestos Cement plastered surfaces including scaffolding if necessary, preparing the surface by thoroughly cleaning oil, grease, dirt and other foreign matter and sand papering as required etc. complete. [As directed by Engineer Inchage] (S.S.R.I.No. 35.21)

Item No. 18 :- Providing and applying plastic emulsion paint of approved quality, colour and shade to new surface in three coats including scaffolding, preparing the surface. (excluding primer coat) etc. complete. [Bd.P.6 P.No. 414 & Pre-approval of Superintending Engineer] (S.S.R. I.No. 36.14)

Item No 19 :- Providing and applying two coats of exterior weather shield paint of approved manufacture and of approved colour to the plastered surfaces including cleaning ,preparing the plaster surface ,applying primer coat ,scaffolding if necessary, and watering the surface for two days etc complete. [As directed by Engineer incharge] (S.S.R.I.No. 35.26)

Item No. 20 :- Providing and fixing Orissa type white glazed earthenware 575 mm water closet pan including S trap with earthenware foot rests, cast iron soil and vent pipe upto outside face of the wall 1:2:4 brick bat lime concrete bedding without flushing tank and its accessories etc. complete. [As directed by Engineer incharge.] (C.S.R.I.No. 42.30 P.No. 366)

Item No. 21 :- Providing and fixing 100 mm dia stabiliser pipe/ P.V.C. soil vent/waste pipe and with necessary fixtures and fitting such as bends, tees, single junctions, slotted vent, clamps etc. complete. [As directed by Engineer incharge.] (C.S.R.I.No. 42.52 P.No. 268)

Item No. 22 :- Providing and fixing on walls/ ceiling/ floor 20 mm dia. CPVC pipe with necessary fittings, remaking good the demolished portion etc. complete. Including removing existing pipe line if necessary and conveying & stacking the same in PWD chowky or as directed etc. complete. [BD.V 5 P. 551 & as directed by Engineer in charge] (SSR I.No. 42.56)

Item No. 23 :- Providing and fixing 15 mm dia. screw down bib/ stop tap of brass including necessary socket union nut complete. [Bd.V.8/Page No.554 (SSR item No. 41.40 P.No. 258)

Item No. 24 :- Providing and constructing Brick Masonry Inspection Chamber 60cm x 45cm x 90cm including 1:4:8 cement concrete foundation 1:2:4 cement concrete channels half round G.S.W. pipes Brick Masonry plastering from inside & with frame fixed in cement concrete with R.C.C. Cover medium duty 140 kg with frame etc complete [Bd.V.43 P. No. 574] (SSR item No. 42.12 P.No. 264)

Item No. 25 :- Providing soak pit of size 120cm x 120cm x 120cm including excavating and filling with brick-bats. [Bd.V.46, Page No. 576] (SSR item No. 42.19 P.No. 264)

Item No. 26 :- Providing and fixing H.D.P container Syntex or alike one piece moulded water tank made out of high density polythyler and built corrugated inclusive of delivery up to destination hoisting and fixing of accessories such as inlet,outlet overflow pipe inclusive of all tanks capacity between 200 to 1000 liters [As directed by engineer-in-charge.] (SSR item No. 42.53 P.No. 267)

Item No. 27 :- Providing and fixing White glazed with bottle trap earthenware Wash Hand Basin of 63x45 cm size including cold water piller taps, brackets, rubber plugs and brass chain, stop tap, chromium plate bottle trap and necessary pipe connections including UPAC waste pipe and trap upto the outside face of the wall, making good the damaged surface, testing etc. complete. [BDV.-30 P.No.616] (SSR item No. 41.70 P.No. 261)

Item No. 28 :- Providing and fixing stainless steel sink of size 600 x 510 x 200 mm incluidng coupling, outlet pipe, elbow and other necessary fitting, finishing etc. complete. [As directed by Engineer in charge] (SSR I.No. 42.78)

Item No. 29 :- Excavation for roadway in earth, soil of all sorts, sand, gravel or soft murum including dressing section to the required grade, camber and side slopes and conveying the excavated materials with all lifts upto a lead of 50m. & spreading for embankment or stacking as directed. [MORTH 301] (S.S.R. I.No. 2.11 P.No. 85 )

Item No. 30 :- Providing and laying in situ / ready mix M-20 cement concrete of trap /granite /quartzite /gneiss metal for approach slab / Rigid pavement including compacting, finishing, curing etc. complete. (excluding reinforcement) (with reversible drum type mixer/ concrete batch mix plant (pan mixer) with SCADA with fine agreegates of required specifications (Natural sand / VSI sand finely washed etc ), cement 6.40 bags/cumt) [CD.15 P.No. 168 & B.7. P.No. 38] (S.S.R.I.No. 11.25 P.No. 82 )

Item No. 31 :- Providing & fixing heavy duty inter locking concrete RUBBER MOULD GLOSSY PAVING BLOCKS of 60 mm thickness of having a strength of 400 Kg/sqm of approved quality & shape on a bed of crushed sand of 25 to 30 millimeter thick including striking joints & cleaning etc. complete (using 100% crushed sand) [Bd. M12 P.No. 385] (S.S.R. I.No. 33.53 P.No. 211)

Item No. 32 :- Providing and laying Cast in situ/Ready Mix cement concrete in M15 of trap/ granite/quartzite/gneiss metal for steps including steel centering, formwork, laying/pumping, compacting, roughening them if special finish is to be provided, finishing uneven and honeycombed surface and curing etc. complete. The Cement Mortar 1:3 plaster is considered for rendering uneven and honeycombed surface, only. Newly laid concrete shall be covered by gunny bag, plastic, tarpaulin etc. (Wooden centering will not be allowed.),with fully automatic micro processor based PLC with SCADA enabled reversible Drum Type mixer/concrete Batch mix plant (Pan mixer) etc. complete. With fine aggregate (Natural Sand / Crushed sand VSI Grade finely washed etc) [Bd.E.2 P.3No. 288 & B.7 P.No 38] (S.S.R.I.No. 24.04 P.No. 168)

Item No 33 :- Providing and fixing board displaying information, such as 'Name of work, Name of Contractor, Work completion and liability period etc, having rectangular shape of 0.90mx0.60m size made out G.I. sheet painted with oil paint MS angle of size 50x50x6mm frame with properly MS angles including etc & fixing the boards in C.C. M10 concrete block of size 45cmx 45cm x60cm including excavation refilling transportation & labour etc complete [As directed by Engineer in Charge] (As per rate analysis)