UKE Strategischer Einkauf Tender

Contract notice: Supply of Centrifuges 1. Lot 1: 1.1. Laboratory centrifuges (refrigerated): The laboratory centrifuges for the separation of liquid and solid mixtures of different densities are used in the laboratories of the UKE. Different vessels are to be used in parallel with the devices (see Table 1 - minimum requirements). Item lists for accessories and spare parts, including prices, must be attached to the offer. 1.2. Scope of application: The devices are used in clinical and research operations. Therefore, the conditions for devices with and without IVD certificate are requested, see Table 3 â € Investment costs. The minimum requirements can be found in Table 1 - minimum requirements. 1.3. Basic device: Centrifuge for separating aqueous solutions and suspensions of different densities. The devices are intended to be used in different areas. A rotor change must be possible in a few simple steps. The tools required for this must be included in the scope of delivery. â € Holds a wide variety of rotors for centrifuging tubes of different sizes and microtiter plates, - speed of at least 20,000 rpm, â € maximum noise emission 65 dB (A), â € Cooling from room temperature to 4 o C within 30 min. Further criteria can be found in Table T2 - Technical LV Lot 1. 1.3.1. Rotors: Fixed-angle and swing-bucket rotors are to be offered for different application ranges: - for microtiter plates, â € for tubes with the following volumes: 50 mL, 15 mL and 5 mL, - for simultaneous centrifugation of plates / tubes, â € Aerosol-tight rotor. If the rotors do not meet all requirements, another rotor must be offered at no cost, see table T3 - investment costs, lot 1. University Medical Center Hamburg-Eppendorf OV 030-21 centrifuges, UKE KLE-MT / KVo Page 5 of 17 created on 3/10/2021 1.4. Service and training: A 24-month guarantee / warranty period must apply to the systems. Further details can be found in the General Performance Requirements (D) and the Additional Technical Contractual Conditions (E). All devices must be set up and installed completely. The equipment must be brought in while the laboratory is in operation. The instruction in the operation should take place in sufficient form on site and include the device operation in addition to the theoretical basics. This contract