Tenders of The District Of Taylor

It Is The Intent Of This Specification To Provide For The Purchase Of Twenty (20) New Yamaha Drive Afi Golf Carts. Quotations Will Be Accepted For Consideration On Any Make Or Model That Is Equal Or Superior To The Golf Carts Specified. Decisions Of Equivalency Will Be At The Sole Interpretation Of The District Of Taylor’s Director Of Community Services. A Blanket Statement That Equipment Proposed Will Meet All Requirements Will Not Be Sufficient To Establish Equivalence. The Golf Carts Shall Be Delivered F.o.b. Destination, Freight Prepaid, To The District Of Taylor’s Lone Wolf Golf Club In First Class Operating Condition. Contractor Shall State Delivery Time After Receipt Of Order.

Rfp 06-2024 Residential Curbside Garbage Collection

The Owner Invites Bids For Construction Of The Work, Which In General Terms, Will Consist Of The Following: • A Concrete Block Building, Complete With Site Grading, Gravel Parking Lot And Road Access, Sidewalk On The Exterior Of The Building, And Electrical Servicing; • A New Sanitary Manhole That Ties Into The Existing Sanitary; • All Process Piping And Valves Within The Building; And • The Supply And Installation Of Dewatering Centrifuge And All Related Appurtenances.

It Is The Intent Of This specification To Provide Heat Trace For The Outside Drainage Pipe That Runs Along The Building. This Project Is Approximately 140 Meters Long. Measurement Can Be Confirmed At The Site Visit. Our Public Works Team Will Be Digging The Hole And Laying The New 250 Mm Pvc Storm Pipe.   

Rfp-05-2024 District Ice Centre Concession

District Of Taylor Rental Of Office Space

It Is The Intent Of This Specification To Provide For The Purchase Of A Gator Tx 4x2 Utility Vehicle.

It Is The Intent Of This Specification To Provide For The Purchase Of A Grasshopper 328g4efi With 61” Deck, 810 Cc Vanguard Efi Engine.

Header Pipe Replacement Project

It Is The Intent Of This Specification To Provide Installation Of A New Header Pipe In Our Ice Centre. This Consists Of The Existing Cool Floor And Warm Floor Brine Charge To Be Removed From System Prior To Header Demolition. Brine Is To Be Stored Onsite At Contractor’s Expense. The District Of Taylor Will Provide Secure Storage Location. The Existing Headers And Supports To Need To Be Removed And Disposed Of. New Painted Steel Header Brackets To Be Installed Inside Header Trench Every 10’ And At Ends As Required. The Overall Length Of This Project Is 92 Ft. The New Headers To Be Connected To Existing Rink Piping With Flexible Hoses, Nylon Barbed Connectors And Ss Gear Clamps. All Joints Must Receive 2x Gear Clamps Per Side. System To Be Pressure Tested As 50 Psi With Compressed Air For 24 Hours Prior To Recharging With Brine. Air To Be Purged During Brine Charging To Ensure System Is Ready To Service.