Koronadal Water District Tender

Description A. It Shall Meet The Following Operating Requirements: Type: Variable Frequency Drive Horsepower: 60 Or Higher Phase: 3 Frequency: 60hz Speed: 3450 ~ 3600 Rpm Voltage: 230 Volts B. Specification And Features: 1. Pre-wired And Tested Set-up In Nema Enclosure Protection 2. Ul Safety Level Compliance 3. Capable Of Either Manual Or Automatic Application 4. Status Indicator Display 5. Detection Of Underload/ Overload 6. Trouble Log 7. Ingress Protection: 20 Or Higher 8. Includes On-site Programming 9. Dimension: At Least 16”x32”x48” 10. Ventilation System: At Least 4 Fans 11. Built-in Hour Counter 12. Applicable For Both Single-phase And Three-phase Power Supply With 3 Phase Electrical Load C. Complete With The Following Accessories: 1. Main Circuit Breaker, Magnetic Contractor, Overload, Over/underload Voltage, Start/stop Push Button Switch, Hoa Selector Switch, Hour Counter And Frequency, Etc. 2. At Least Twenty (20) Meters Length Of 38mm2 Electrical Wire Compatible To The Maximum Load Of The Unit With Twelve (12) Pieces Terminal Lugs. General Conditions: 1. The Supplier Shall Be Responsible For The Proper Installation Of The Supplied Motor Controller Unit. 2. The Supplier Shall Install The Motor Controller Unit Within Forty-five (45) Days After Signing Of Contract/ Purchase Order (po). The 15-day Time Frame Shall Be Allotted In Order To Check The Proper Setting Of The Motor Controller Unit And Make Necessary Corrections Of Both Mechanical And Electrical Failures Found During Installation And Construction. The Supplier Shall Inform The Ckwd Measures And Proper Procedures On The Unit’s Operation To Guarantee A Smooth And Proper Function Of The Newly-installed Unit. 3. Field-testing Shall Be Made Once The Mounted Equipment Is Ready For Operation And When Both The Ckwd And Supplier Have Finished Their Scopes Of Work On The Installed Unit. Ckwd Engineers Shall Conduct Field Testing With The Presence Of Supplier’s Representative. 4. In Case The Unit Failed During Field Testing, The Supplier Shall Make Necessary Corrections, Repair Or Replace The Unit Without Cost To The Owner. All Incidental Expenses Including The Pulling Out And Transporting Of The Unit Shall Be Borne By The Supplier. 5. All Equipment/materials Must Be Brand New. Additional Requirements: (compliance Upon Submission Of Bid) 1. Must Submit Product Catalog / Brochure. 2. The Manufacturer Should Have Iso 9001:2015 Valid Certificate. Additional Requirements: (compliance Upon Delivery) 1. Must Have Standard Manufacturer’s Installation Accessories. 2. Minimum Manufacturer's Warranty Of One (1) Year.