Water Resources Department Tender

Supplying and drawing following sizes of frls pvc insulated copper conductor, multi strand wire in the existing surface/ concealed, frls pvc conduit /pvc casing capingwith all lead and lifts and cost of all material etc. complete in all respect as per approved design, drawing, and specification and as directed by the engineer in charge.

Provision of tested steel reinforcement for reinforced cement concrete work upto floor level 2, as per drawing, bending, binding and fixing the same, complete in all respects including cost of binding wire and wastage, all leads and lifts and cost of all materials etc. in accordance with the approved design, drawings and specifications and as per the instructions of Engineer-in-Charge.

Arranging and pouring of cement concrete under floors in foundations and plinth and complete including ramming in proportioned mix of 20mm nominal size stone but excluding the cost of ramping and including ramping and padding, supports, supports etc. for Reinforced Cement Concrete and Plain Cement Concrete works in foundations and plinth and opening of ramps and laying of LDEP film under Cement Concrete 1:2:4 (1Cement, 2Sand, 4Gargle) complete in all respects including cost of all leads and lifts and all materials etc. as per approved design, drawing and specification and as per direction of Engineer-in-Charge.

Earth work, filling of bunds in thick excavations and in layers of excavated earth not exceeding 20 cm thick, ramming of clods, watering, ramming of each layer with 1/2 tonne trailer or wooden or iron rods and every third and topmost layers with power driven roller of at least 8 tonne, and filling of pits by ramming upto a distance of 50 m and upto a height of 1.5 m for all types of soil and filling of sand/gravel under the beds in plinths, irrigation, ramming and ramming, complete in all respects including laying under cement concrete, all leads and lifts and cost of all materials etc., as per approved design, drawing and specification and as per the instructions of Engineer-in-Charge.

Supplying, installation, testing and commissioning of hybrid solar street luminaire of housing made of extruded aluminium and ip65 ingress protection. the all in one solar street lighting system having system lumen output up to 120 lpw (as per lm79 report of nabl accredited lab only), cct of 6500k (+/- 500k) and cri > 70, l70 should be of 50000 hours or more. the luminaire should be having smd type leds with secondary lens / optics suitable for street lighting application, mppt charge controller and dc driver and automatic dusk to dawn operation feature. the all in one solar street light must have hybrid feature under which led light can be operate by both ac mains & dc supply. the integrated luminaire should have monocrystalline pv module, lithium battery pack having upto 10h rs. of autonomy with full power mode and upto 36hrs. of autonomy with saving mode. specially designed in built pir sensor allows to sense motion i.e. if a human is within sensor range then streetlight is at 100% full power lighting mode otherwise if no movement is detected to save energy it dims down to 30% of power with all lead and lifts and cost of all material etc. complete in all respect as per approved design, drawing, and specification and as directed by the engineer in charge.

Earthing with g.i. earth pipe 4.5 metre long, 40 mm dia including accessories, and providing masonry enclosure with cover plate having locking arrangement and watering pipe etc. with charcoal and salt with all lead and lifts and cost of all material etc. complete in all respect as per approved design, drawing, and specification and as directed by the engineer in charge.

Erection of steel tubular or

Earth work (30 cm in depth by 1.5 m in width and more than 10 sq. m in area) including excavation of areas, levelling and neat raking of excavated earth upto a distance of 50 m and 1.5 m in height and cleaning of site, cutting of grass, collecting and stacking it and removing it from premises and jungle clearance including uprooting of stunted vegetation, grass, bushes and vegetation upto a radius of 30 cm and removing them to a distance not exceeding 50 cm outside the boundary of cleared area, complete in all respects including cost of all leads and lifts and all materials etc., in accordance with approved design, drawing and specification and as per the directions of Engineer-in-Charge.

Supplying and laying 6 swg g.i. wire at 0.50 metre below ground level for conductor earth electrode, including soldering, excavation and refilling the trench with all lead and lifts and cost of all material etc. complete in all respect as per approved design, drawing, and specification and as directed by the engineer in charge.

Supply of swaged steel tubular pole as per is 2713 with base plate of size 300x300x6mm welded at bottom, necessary hole for cable entry and earthing stud welded at specified height including painting with one coat of red oxide zinc chromate primer etc. complete in all respect as per approved design,drawing,specification and as directed by engineer-in-charge.

Erection of information board as per the prescribed standards at the site complete in all respects including painting, marking, all leads and lifts and all materials etc. at cost in accordance with the approved design, drawing and specification and as per the instructions of the Engineer-in-Charge.

Supplying and laying following sizes one number frls pvc insulated/ xlpe, pvc sheathed, unarmoured, aluminium conductor power cable of 1.1 kv grade on surface/ existing cable tray with 1 mm thick gi saddle with all lead and lifts and cost of all material etc. complete in all respect as per approved design, drawing, and specification and as directed by the engineer in charge.