Vehicle Tenders

Details: CATEGORY: Repair, Maintenance, and Installation of Plant/ Systems/Equipments (Version 2) - Office Space; Vehicles; Service Provider

Description: C/o School Bldg , Boys And Girls Hostel Including Warden Residence , Principal Qtr , 15 Nos Type Iii Qtrs And Guest Room , 10 Nos Type Ii Qtrs Kitchen And Dinning Sub Ststion And Pump Room Including Internal Water Supply And Sanitary Isntallations, Drainage Compound Wall Developement Of Site And Bulk Service Civil And Electrical Of Emrs At Uplat Talasari Palghar Maharashtra Subwork/packages:hiring Of Inspection Vehicles For Sub Division I Office , Boisar

Details: Estimated Rate For Tractor Model Hmt 3522 Fx Following Spare Parts To Be Used At Motor Vehicles Department Of Bally Municipality

Description: Qty- 150 Mt (approx) Scrap Ferrous Material, Consisting Of Released Unserviceable Wagon Items Like Panels, Wagon Doors, Side Or End Body Portions, Underframe Portions And Structure Materials Etc. These May Be Mixed With P.way Scrap Materials E.g. Rails, Sleepers Etc. Which Are To Be Segregated And Not To Be Taken For Disposal. Above Scrap Are Lying On The Ground, As Well As Under Debris/heaps, Among Vegetation/shurbs Etc. Purchasers Are Allowed To Dig The Heaps, Pull/shift Scrap Items Up To The Road Vehicle Using Jcb/excavator/hydra Etc., Segregate The Items, Cut The Ferrous Scrap If Desirable, Lift And Shift The Scrap Material To Gsd/raipur For Weighment. Purchasers Have To Collect And Dispose The Scrap Material From The Locations In Same Order As Mentioned, I.e. Dispose All Scrap From Location (i) First And Then From Location(ii), Until 150 Mt Quantity Is Disposed. Nb: (i) Purchasers Are Not Allowed To Lift Any P.way Scrap Material E.g. Rails, Sleepers, Etc. (2) Weighment Of The Scrap Material Shall Be Taken At Gsd/r For Delivery Purpose. (3) The Offered Scraps Is On "as In Where Is" Basis. Bidders Are Advised To Visit The Site First, For Assessment Of Work. (4) As Locations Are Inside The Workshop, All Factory Safety Procedures Regarding Gas Cutting, Material Handling Are To Be Followed. (5) Site Involves Underground 415 V Electrical Cables, Due Care Should Be Taken To Not Damage Them.

Description: 98050114 Scrap Released Condemned M.s. Scrap Items I.e. Break Load Rings, Pins, Bushes, Dash Pots,collars, Vehicle Spares, Ohe Fittings, Break Liner, Thrust Bearing, Yoke, Block Hangers, Slides, Locking Rods, Partsof Point Machine, A B Cover, Break Head, Cylinder Head, Pcs. Of Break Beam, Protective Tubes, And Other P-way Fittings, Screw, Bolts, Spikes, Keys, Loco Parts, Stay Rods, Sleeve For Centre Pivot, Pantograph Parts, Palmpull Rods, Lever , Air Motor Springs Of Pantograph, Small Rail Pieces, Connecting Rods, And Other Rods, Rearcover Of Axle Box Housing, Longer Hanger, Spare Parts Of Spt Machine, Pipe Fittings, End Shield Covers, Breakbeam Hangers, Break Shoe , Vertical Lever, Suspension Levers, Compressor Spares, Tension Rods, Coupler,knuckles, Broken Pcs. Of Bearings, Inner And Outer Race Of Bearings, Spares Of Break Valve, Trolley Wheels,clamps, Bmbc Parts, Pump Shafts, Impellers, Tension Device Parts, Fan Armatures, Chain Sling, Rev. Centre, Hooks, Spares Of Trucks, Accessories Of Transformer,fish Plates,hooks, Silent Blocks, Cut Pieces Of Plates, Ms Sheets, Doors,angles Etc. , Fasteners Such As Bolts, Nuts And Other Related Misc. C And W Items Etc. Of Sorts And Sizes, Broken And Damaged, Etc.. Custodian Cdms Fe Prtn, Fdp = 40 Days. Revision Of Lot No. 622411019.

Details: Selection Of A Service Provider For Centralized Printing Of Registration Certificates And Driving License For Motor Vehicles Department In The Ut Of Andaman And Nicobar Islands For A Period Of 5 Years

Description: 031324100045 98110159 (01) (hsn Code: 72044900- Gst 18% On Fcm Basis), Scrap Of Cond. &u/s 8 Wheeler Wagon Bcn M1 , Boxn M1, , Available On Rails. 1) Cr Bcn M1 30018964049, 2) Nfr Boxn M1 10059161997, 3) Nr Bcn M1 30038905589 , 4) Ser Bcn M1 30078961736,5) Cr Bcn M1 30018960492 Location Road No.2 At Dump Yard. Rc Items: 1.coupler Bodies (nt), 2. Yokes 3. Knuckles ,4.draft Gears, 5.striker Castings (nt), 6. Centre Pivots 7.wheel Set With Ctrb, 8.casnub Bogies With All Fittings,9.yoke Pin Support (1st Plate),10. Safety Plate With Anchor Plate (2n D Plate 11. Yoke Support Plate(3rdplate), 12., Yoke Pin, 13) Draft Gear Followers,14. Knuckle Pin 15.bcn Swing.16. Boxn Doors Ds8 No:0999603045 .dt:07.10.24. Note To Purchaser: Before Delivery Of Wagon Cut Off Parts, The Declared Rc Items Need To Be Handed Over By The Purchaser To Sse/scrap At Shop Floor By Transporting Through Purchaser¿s Vehicle/labor Approx Weight: 66.513 .mt Sold On Number Basis Only Delivery In Cut Up Parts. Note:-if Any Non Ferrous Items Found In Cutting/delivery, Purchaser Should Be Handed Over To Railways. 05 Nos.

Description: 031324100043 98110159 (01) (hsn Code: 72044900- Gst 18% On Fcm Basis), Scrap Of Cond. &u/s 8 Wheeler Wagon Bcn M1 , Boxn M1, , Available On Rails. 1 ). Nr Bcn M1 30038960083, 2) Nr Bcn M1 30038961790,3) Cr Bcn M1 30018763086, 4) Scr Boxn M1 10079406344, 5 ) Ner Bcn M1 30048961322, 6) Ser Bcn M1 30078963815 Location Road No.2 At Dump Yard. Rc Items: 1.coupler Bodies (nt), 2. Yokes 3. Knuckles ,4.draft Gears, 5.striker Castings (nt), 6. Centre Pivots 7.wheel Set With Ctrb, 8.casnub Bogies With All Fittings,9.yoke Pin Support (1st Plate),10. Safety Plate With Anchor Plate (2n D Plate 11. Yoke Support Plate(3rdplate), 12., Yoke Pin, 13) Draft Gear Followers,14. Knuckle Pin 15.bcn Swing. Ds8 No:0999603043 .dt : 07.10.24. Note To Purchaser: Before Delivery Of Wagon Cut Off Parts, The Declared Rc Items Need To Be Handed Over By The Purchaser To Sse/scrap At Shop Floor By Transporting Through Purchaser¿s Vehicle/labor Approx Weight: 82.668 .mt Sold On Number Basis Only Delivery In Cut Up Parts. Note:-if Any Non Ferrous Items Found In Cutting/delivery, Purchaser Should Be Handed Over To Railways. 06 Nos.

Description: CATEGORY: Wood Lathe machine 01 nos , Drilling machine , Power Jig Saw , Wood cutting and Planing machine , Grinding machine Qty 3 Nos , Power band saw 01 Nos , Floating dock model , ICCP training jig , Anchor and capstan , Lathe machines Qty 5 Nos , Pipe bending machines Qty 1 Nos , Compressor 500 Ltrs Min Qty 01 , Compressor 420 Ltrs Min Qty 01 , Compressor 200 Ltrs Min Qty 01 , Radial Davit , Bow door and Ramp Door 2 nos , Radial Drilling Machine , Twin arm davit , Single Arm Davit , Accommodation Ladder , Sewage Treatment Plant , Vacuum Toilet System , Hydraulic Davit model , Hydraulic Hangar Door model , Fork Lift , Electrical Lister Vehicle , Deck Washing Machine , Lathe Machine with accessories Manufacturer Parmar Mechanic Works , Barmi Miling Machine , Disc Grinder 3 inch , Double Disc Grinder DDS 18 inch , Pelicon Combined Surface Thickness Model SSPI , Air Compressor with accessories , Drilling Machine Swift Bench Type , Circular saw bench rise and fall , Pelico n Wood and Metal Bend Saw Machine , Facit saw Machine , Pencil Grinder Size 6 inch , Hard field Circular Saw machine , Jig Saw machine with square table pedestal , Bench Lathe Machine , Helo Traversing System HTS Make L and T , Foldable Hanger Door FHD Make L and T

Description: 031324110055 98110159 (01) (hsn Code: 72044900- Gst 18% On Fcm Basis), Scrap Of Cond. &u/s 8 Wheeler Wagon Bcn M1 , Bfkhn, Available On Rails. 1) Cncr Bfkhn 98258870810,2) Er Bcn M1 30028960758 3) Er Bcn M1 30028967306,4) Er Bcn M1 30028961366,5) Cr Bcn M1 30018962939 Location Road No.3 At Dump Yard. Rc Items:1.coupler Bodies T 2.coupler Bodies (nt), 3. Yokes 4. Knuckles ,5.draft Gears,6. Striker Castings T, 7.striker Castings (nt), 8.centre Pivots 9.wheel Set With Ctrb,10. Casnub Bogies With All Fittings,11.bcn Swing 12.yoke Pin Support (1st Plate),13. Safety Plate With Anchor Plate (2n D Plate 14. Yoke Support Plate(3rdplate), 15. Yoke Pin, 16) Draft Gear Followers,17. Knuckle Pin , Ds8 No:0999603055 .dt : 13.11.24. Note To Purchaser: Before Delivery Of Wagon Cut Off Parts, The Declared Rc Items Need To Be Handed Over By The Purchaser To Sse/scrap At Shop Floor By Transporting Through Purchaser¿s Vehicle/labor Approx Weight: 65.325 Mtsold On Number Basis Only Delivery In Cut Up Parts. Note:-if Any Non Ferrous Items Found In Cutting/delivery, Purchaser Should Be Handed Over To Railways. 05 Nos.