Tenders of Bgis Pwgsc Rp1

Goc3691999 - Cs - Climate Risk And Vulnerability Assessment

Chiller Condenser End Resurfacing

Chiller Condenser End Resurfacing

Scope Of Work/overview: .1re-roof The Existing 2-ply Modified Bitumen roofing System On The Main Roof And The penthouse Roof. Re-roof The Existing Inverted roof Membrane Assembly (irma) At The Radio Shop (detached Building) With A New 2-ply Modified bitumen Roof Membrane System. Slope New roofing Systems To Existing Roof Drains. replace Or Retrofit Existing Roof Drain Inserts as Required. .2 Temporarily Disconnect And Lift/support Or remove The Existing Rooftop Condensing Unit On the Main Building To Permit Re-roofing. Then reinstall, And Reconnect Upon Completion Of The Roofing Work. Provide Pre-construction And post-construction Start-up Of Condensing Unit, confirming Proper Operation. .3 Remove And Dispose Of The Existing Obsolete Roof top Unit On The Radio Shop Prior To Re-roofing. infill Resulting Roof Opening Prior To re-roofing. .4 Remove And Dispose Of The Approximately 9 Metre tall Chimney, Above The Penthouse Roof And All of Its Associated Guy Wires, Anchors, Antennas, power And Communication Cables, Conduits, And Connectors To Approximately 600mm Below The penthouse Roof. Infill The Resulting Opening in The Penthouse Deck (metal With Concrete topping) Prior To Re-roofing. .5 Remove And Dispose Of The Asbestos Containing panels At The Top Of The Chimney. .6 Remove And Disposal Of Obsolete Exterior wall-mounted Equipment, Conduit, And Cable From the Northwest Wall Of The Penthouse And The patch And Seal Any Holes In The Cladding. .7 Remove And Dispose Of Obsolete supports/sleepers From Previously Removed rooftop Equipment.

Replace Ac Unit And Fan Coil

Repair Or Replace Deficient Fixed Ladders As Per Soulard Report

.1 All Demolition Work As Indicated On Drawings. .2 Remove Fuel Tank And Associated Piping And Dispose Of In Accordance With Canadian And Newfoundland Environmental Regulations. .3 Supply And Installation Of New Stand-by Diesel Generator And Automatic Transfer Switch. .4 New Generator To Be Located On New Concrete Pad. .5 New Generator To Be Connected To The Existing Fire Alarm System For Monitoring Purposes Throughout The Building. .6 Provide New Single Line Diagram To Reflect 100% Of All Existing And New Electrical Equipment. Contractor Is Responsible To Verify All Panel Sizes Including Voltage And Phase. All Panelboard Feeders Are To Be Confirmed And Identified. .7 All Panelboard Directories That Are Affected In This Contract Shall Be Revised And Re-typed. .8 Supply And Installation Of New Service Entrance Board, Panels And Disconnects. .9 The Removal Of Existing Electrical Service And The Installation Of New. .10 Coordination With Nf Power. .11 New Chain Link Fence Around New Stand-by Generator. .12 Provide Arc-flash And Load Coordination Study For Complete Distribution System Including All Existing And New Electrical Equipment.

Install A New Back-up Electrical Power Supply Generator

Hvac Maintenance & Inspections - New Brunswick

Replacement Of Emergency Power Distribution System