Compactor Tenders

Details: Operation And Comprehensive Maintenance For 12 Nos. Of Lmv Compactors Of 6 Cu.m Capacity Of Zone Iv Lorry Station For A Period Of 365 Days

Details: Operation And Maintenance Of 7 (seven) Nos. Stationery Compactors And 2 (two) Nos. Hook Loader For Bidhanagar Area (from Ward No.28 To 41) Under Bidhannagar Municipal Corporation.

Details: Providing And Fixing Compactors In Room No 302 In Office Of Dy. Che Roads W.s At Awing, Municipal Godown Bldg. 90ft Road, Thakur Complex, Kandivali East

Details: Description:- Launching Of Precast Rcc Box Segments Of Any Size And Barrel Length For Single/double line As Per Approved Drawings To The Correct Alignment And Position In Electrified / Non-electrified sectionssafeguarding Allutilities(s&tcable,powercable,ohe,pipelinesetc.)including transportation Of Box Segments From Casting Yard To Site Of Launching, Dismantling Of The Existing track, Removing & Stacking Of Ballast, Removing Surcharge, Dismantling Of Existing Bridge Built With stone Masonry / Cement Concrete Including Cutting Of Formation, Placing Of Box Segments In Position either On Base Slab Or Prepared Foundation, Backfilling After Launching Of Precast Box Segment And compaction Of Earth In Surcharge, Ballasting & Re-laying Of Track To Correct Alignment And Geometry, packing And Further Maintenance Till Allowing Non-stop 20 Kmph Over The Re-laid Track, Complete In All respect As Per Approved Drawing To The Satisfaction Of Engineer-in-charge. The Rate Is All Inclusive except The Cost Of Rcc Box Segments, Base Slabs (if Required) And Backfill Material Which Shall Either be Supplied By Railway Or Paid Extra Under Relevant Item.note: Unit Of 'each' Here Means Bridge Of span(s) With A Total Linear Waterway Up To 3m. Double Line Note: Minimum Equipment Required Shall be (i) Crawler Mounted Hydraulic Excavator Of Min 200 Hp And Bucket Capacity 2.5 Cum - 3 Numbers (ii) Cranes Minimum 200 T Capacity - 3 Nos., (iii) Stone Breaker - 1 No., (iv) Road Trailer Of 20 Mt capacity - 1 No., (v)tippers - 2 Nos. And (vi) Tractors - 2 Nos. (vii) Slope Vibratory Compactor - 2 Nos. and Other Required Machineries Etc. In Good Working Condition At Site Of Work.

Description: CATEGORY: Stainless Steel Tactile Stud , Adhesive Caution Tape , P V C Flo o rin g , C h a r c o al L o u v e r s , Student Lockers , Bench , Shoes Locker , D e e p Cle a nin g o f S t air c a s e , Lin e a r C eilin g , A u t o m a tic Gla s s D o o r s , Fir e E x tin g uis h e r , P V C Pla n t e r s wit h M S F r a m e f o r Ve r tic al G a r d e n , S t o n e M u r al , Installation of Log o wit h Lig h tin g , Rajasthan Map , Cleaning of Ladies Gents Toilets Waterproofing , Unisex Handicap Toilet , Janitor Trolley with Equipment , P e rf o r a t e d L a s e r - C u t M e t al Panel for Stair Window , Bulletin Board , Suggestion Box , Linear Ceiling , Automatic Glass Doors , Reception Table with back lo g o t o p p a n el lighting , R e c e p tio n C h air , Newspaper, Magazine, and New Arrival Books Rack , C o ff e e Ta ble , W o o d e n Flo o rin g , Decorative Planters , Fir e D o o r , E m e r g e n c y S t air c a s e , PVC Planters with MS Frame for Emergency Staircase Vertical Garden With lighting , Q u o t e s a n d sig n a g e , Compactors , Digital Display Board for Library , Providing and Fixing Library Wallpapers on Wall Panels , G y p s u m C eilin g , C a r p e t , W o o d e n Blin d s , Book Rack Double Side , Book Rack Single Side , Height Adjustable Table , Book trolley for library , Step Ladder , Providing and Fixing of Workstation. , Study Chairs , Glass Door , Gypsum Ceiling , Charcoal Louvers , Wooden Blinds , Workstation , G y p s u m B o a r d P a r titio n Installation , Interactive Display , Dis c u s sio n Ta ble , Dis c u s sio n C h air , D e c o r a tiv e Pla n t e r s , Gla s s D o o r , P r o vidin g a n d Fixin g o f W o r k s t a tio n , Providing and Fixing of Workstation , W o r k S t a tio n C h air , Electrical Works for Library , DUCTABLE UNITS , Air C o n ditio n e r , R FID S t a ff S t a tio n , Tw o E A S P e d e s t als R FID S e c u rit y G a t e , Self Check-In Out Kiosk Station , RFID Book drop box Station , R FID E n a ble d S m a r t C a r d P rin t e r , H a n d h eld R FID R e a d e r , Fully Automatic Swing Gate with controller and Face cum card reader , Computer , RFID Tags for Book , Smart Cards , Anti- Theft Stickers customizable , Integration Module Middleware Features , Pasting and programming of RFID Tags , Providing Manpower , R e m o v e a n d r e fix e d

Details: CATEGORY: Supply and fixing of Automatic Bar Screen , Supply and fixing of Sewage Transfer Pumps , Supply and fixing of Dissolved Air Flotation System , Supply and fixing of FOG Free water Transfer Pumps , Supply and fixing of FOG Transfer Pumps , Supply and fixing of Bio Media MBBR Stream 1 and 2 , Supply and fixing of Tube Settler Media Settling tank 1 and 2 , Supply and fixing of Air Blower with Motor , Supply and fixing of Diffusers for Aeration Tank Stream 1 and 2 , Supply and fixing of Diffusers for Anoxic Tank Stream 1 and 2 , Supply and fixing of Filter Backwash Pumps 1 Working 1 Stand by , Supply and fixing of DO Indicating Controller cum Transmitter , Supply and fixing of Pressure Sand Filter , Supply and fixing of Activated Carbon Filter , Supply and fixing of Basket Strainer , Supply and fixing of Dosing System , Supply and fixing of Flow Meter EMF , Supply and fixing of Flow Meter , Supply and fixing of Gratings , Supply and fixing of Level Switch , Supply and fixing of Sludge FOG and F Fat, Oil, Grease and Floatables Compactor , Supply and fixing of Sludge Dryer , Supply and fixing of 100mm dia UPVC pipe , Supply and fixing of 80mm dia UPVC pipe , Supply and fixing of 63mm dia UPVC pipe , Supply and fixing of 50mm dia UPVC pipe , Supply and fixing of 4 inch Butterfly valves , Supply and fixing of 3 inch Butterfly valves , Supply and fixing of 2 and half inch Butterfly valves , Supply and fixing of 2 inch Butterfly valves , Supply and fixing of 4 inch Flop type , Supply and fixing of 3 inch Flop type , Supply and fixing of 2 and half inch Flop type , Supply and fixing of 2 inch Flop type , Supply and fixing of MF Backwash Pump , Supply and fixing of Bag Filter , Supply and fixing of Strainer , Supply and fixing of Micro Filtration Module , Compressor for Automation Valves and MF Air Scoring , Supply and fixing of Automation Panel , Supply and fixing of Automation Valve , Supply and fixing of Automatic Reject Control Valve , Supply and fixing of Air Relief Valve , Supply and fixing of Air Flow Meter , Supply and fixing of Pressure Gauge , Supply and fixing of Pressure Transmitter for MF , Supply and fixing of CIP Pump , Supply and fixing of MF SKID , SITC of electrical panel 125A PANEL 1 , SITC of electrical panel 125A PANEL 2 , SITC of electrical panel 125A PANEL 3 , Supply and fixing of LT cable 2C X 1 point5 Sq mm , Supply and fixing of LT cable 3C X 1 point5 Sq mm , Supply and fixing of LT cable 2C X 2 point5 Sq mm , Supply and fixing of LT cable 3C X 2 point5 Sq mm , Supply and fixing of LT cable 3C X 4 Sq mm , Supply and fixing of LT cable 3C X 6 Sq Mm , laying of LT cable 35 Sq mm , Supply and fixing of LT cable 300mm X 50mm x 1 point 6mm , Supply and fixing of LT cable 100mm X 50mm x 1 point 6mm

Details: Description:- Cess Repair/widening Work As Per Rdso Specifications And Guidelines Rdso/2020/ge: irs-0004 Or Latest In Running Line With Suitable Soil To The Designed Profile The Work Shall Include uprooting And Disposing Of All The Vegetation, Benching At Every 30 Cm Vertical Height, Earthwork In benching Portion And Compaction Using Suitable Slope Vibratory Rollers/compactors Etc. To Achieve prescribed Mdd. Note: 1. Payment Of Cess Repairs Shall Be Based On The Quantities Worked Out From the Cross Sectional Calculations Only And Worked Out From The Initial Ground Levels Before Doing benching And Final Levels As Done For New Embankment. The Earth Work In Benching Portion Shall Not be Paid Extra As The Same Has Been Included In The Rate. 2. The Earth Work Shall Be Started Only After completing Of The Benching And Certified. 3. The Benching Work Shall Be Done For A Maximum Height of 1.50 M At Any Time Based On The Progress Of Earthwork Starting From Toe Of The Embankment.

Details: Description:- Cess Repair/widening Work As Per Rdso Specifications And Guidelines Rdso/2020/ge: irs-0004 Or Latest In Running Line With Suitable Soil To The Designed Profile The Work Shall Include uprooting And Disposing Of All The Vegetation, Benching At Every 30 Cm Vertical Height, Earthwork In benching Portion And Compaction Using Suitable Slope Vibratory Rollers/compactors Etc. To Achieve prescribed Mdd. Note: 1. Payment Of Cess Repairs Shall Be Based On The Quantities Worked Out From the Cross Sectional Calculations Only And Worked Out From The Initial Ground Levels Before Doing benching And Final Levels As Done For New Embankment. The Earth Work In Benching Portion Shall Not be Paid Extra As The Same Has Been Included In The Rate. 2. The Earth Work Shall Be Started Only After completing Of The Benching And Certified. 3. The Benching Work Shall Be Done For A Maximum Height of 1.50 M At Any Time Based On The Progress Of Earthwork Starting From Toe Of The Embankment.

Details: Description:- Cess Repair/widening Work As Per Rdso Specifications And Guidelines Rdso/2020/ge: irs-0004 Or Latest In Running Line With Suitable Soil To The Designed Profile The Work Shall Include uprooting And Disposing Of All The Vegetation, Benching At Every 30 Cm Vertical Height, Earthwork In benching Portion And Compaction Using Suitable Slope Vibratory Rollers/compactors Etc. To Achieve prescribed Mdd. Note: 1. Payment Of Cess Repairs Shall Be Based On The Quantities Worked Out From the Cross Sectional Calculations Only And Worked Out From The Initial Ground Levels Before Doing benching And Final Levels As Done For New Embankment. The Earth Work In Benching Portion Shall Not be Paid Extra As The Same Has Been Included In The Rate. 2. The Earth Work Shall Be Started Only After completing Of The Benching And Certified. 3. The Benching Work Shall Be Done For A Maximum Height of 1.50 M At Any Time Based On The Progress Of Earthwork Starting From Toe Of The Embankment.

Details: Description:- Cess Repair/widening Work As Per Rdso Specifications And Guidelines Rdso/2020/ge: irs-0004 Or Latest In Running Line With Suitable Soil To The Designed Profile The Work Shall Include uprooting And Disposing Of All The Vegetation, Benching At Every 30 Cm Vertical Height, Earthwork In benching Portion And Compaction Using Suitable Slope Vibratory Rollers/compactors Etc. To Achieve prescribed Mdd. Note: 1. Payment Of Cess Repairs Shall Be Based On The Quantities Worked Out From the Cross Sectional Calculations Only And Worked Out From The Initial Ground Levels Before Doing benching And Final Levels As Done For New Embankment. The Earth Work In Benching Portion Shall Not be Paid Extra As The Same Has Been Included In The Rate. 2. The Earth Work Shall Be Started Only After completing Of The Benching And Certified. 3. The Benching Work Shall Be Done For A Maximum Height of 1.50 M At Any Time Based On The Progress Of Earthwork Starting From Toe Of The Embankment.