Public Works Department Tender

Tack coat - Providing and applying Tack coat with bitumen VG-10 using rate of 0.35 kg per sqm on the prepared granular surfaces treated with primer & cleand with Hydraulic broom as per Technical Specification Clause 503 (Including cost of Bitumen VG-10)

Open Graded Premixed Carpet:- Providing, laying and rolling of open-graded premix carpet of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using penetration grade bitumen VG 10 to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheel 80-100 kN static roller capacity, finished to required level and grades to be followed by seal coat of either Type C as per Technical Specification Clause 508.(Using Hot Mix Plant) (Including cost of Bitumen VG-10)

Seal coat - Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using type "C" as per Technical Specification Clause 510(Using Hot Mix Plant) (Including cost of Bitumen VG-10)

Cement Concrete Pavement: Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days using curing compound (where specified) and water finishing to lines and grade as per drawing and tenchinal specifications clause 1501.

Construction of subgrade & shoulders with approved material obtained from available land as permitted and approved by Engineer-in-charge and as per technical specification clause 301.3.4.1 with all lifts and leads, spreading grading to required slope and compacting to meet requirement of Tables 300.1 and 300.2 as per technical specification clause 301.5. (Patri)