Rural Development Department Tender

Providing and applying tack coat with Bitumen emulsion (RS-1) using emulsion distributor at the rate of 0.20 kg per sqm on the preparedbituminous/ granular surfaces cleaned with Hydraulic broom as per Technical Specification Clause 503 of MoSRT&Hspecification for road & bridge works Including cost, conveyance, cess, taxcess(Excluding GST), royality of materials etc. complete required for the work as per specification and direction of Engineer- in charge

Construction of road side berms with approved materials deposited at site from roadway cutting and excavation from drain and foundation of other structures graded and compacted to meet requirement ,with all cost of labour,material(Excluding GST), royality of materials etc. complete required for the work as per specification and direction of Engineer- in charge. (excluding cost of excavation and transportation to site).

Providing and laying semi dense bituminous concrete with batch type of hot mix plant using crushed aggregates of specified grading premixed with bituminous binder of 60/70 penetration grade of bitumen with addition of processed waste platic of above 10% weight of bitumen, transported to site, laid over a previously prepared surface with a hydrostatic paver finisher with sensor control to the required grade, level and alignment and rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per Clause 508 of MoSRT&H Specifications for Road & Bridge works with all cost of labour,material(Excluding GST), royality of materials etc. complete required for the work as per specification and direction of Engineer- in charge.

Earth work in hard soil both side berms with approved material obtained from borrow pits with all lifts and leads, transporting to site by mechanical means with ordinary compction by PRR ,all lead s, spreading, grading , cost of labour, machinaries,T&P, cost of transportation,royality, hire charges,taxes(Excluding GST) etc. complete as per specification and direction of the Engineer-in-charge.

Construction of Panelled cement concrete pavement, thickness as per design, over a prepared sub-base, with 43 grade cement or any other type as per Clause 1501.2.2, M30 (grade) coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25mm mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the form work as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars near approaches to bridges and culverts (expansion joints), admixtures as approved, curing of concrete slabs for 14 days, curing compound and water finishing to lines and grade as per drawing and Technical Specification Clause 1501.Including all cost of labourT&P(Excluding GST), cost of transportation, hire charges etc. complete as per specification and direction of the Engineer-in-charge.

Providing reinforced cement concrete M15 grade kilometer stone/local stone of standard design as per IRC:8 fixing in position including painting and printing, etc as per drawing and T&P, cost of transportation,royality, hire charges,taxes(Excluding GST) etc. complete as per specification and direction of the Engineer-in-charge.

Ordinary KM stone

Providing display-sign board constructing of brick work using 23x11x8 cm sizeKB/ fly ash brick inclding plastering, painting and lettering with all cost(Excluding GST), labour,lead, T&P reqired for the work etc complete as per direction of engineer in charge.

Providing and fixing of semi reflective cautionary, mandatory and informatory sign board as per IRC:67 made of 1.5 mm thick MS Sheet duly stove white colour in front and gray colour on back with red reflective border of 65 mm width and required letters and figures with reflective tape engineering grade as per Clause 1701.3.9 of MORD for Rural Roads of required shade and colour supported and welded on 47mm x 47 mm x 12 SWG sheet tube firmly fixed to the ground by mean of properly designed foundations with M-15 grade cement concrete 450x450x600 mm, 600 mm below ground level as per approved drawing Clause 300,800,1700.Including all cost of labour, material,(Excluding GST) ,T&P, cost of transportation, hire charges,cess etc. complete as per specification and direction of the Engineer-in-charge.

Earthwork in excavation for foundation of structures in all types of soil as per drawing and technical specification Clause 305 and 1104 of MoRD includding setting out, construction of shoring and bracing, removal of stumps and other deleterious material and disposal upto all lead & lift, dressing of sides and bottom and back filling with excavated suitable material upto 3mt. as per direction of Engineer-in-Charge.

Providing filling manually with selected sand in layers not exceeding 150mm thick including levelling, watering compcting with all cost of labour,conveyance,royality, taxes(Excluding GST) etc. complete as per drawings and technical specifications and direction of the Engineer-in-Charge.

Providing laying concrete for plain cement concrete(1:3:6)with using 40mm size crusher broken hard granite metal in foundations including preparation of form work,preparation of mix in mixture machine,laying compacting by vibrator, finishing, curing of concrete for 14 days with all cost , cost of labour,conveyance,royality, taxes(Excluding GST) etc completeform work as per drawings and technical specifications and direction of the Engineer-in-Charge.

White washing two coats with approved brand on concrete work, parapet wall, tree trunks, guard post after through cleaning of surface to give an even shade including all cost of labour,cost of colur,brushes,T&P, all taxes(Excluding GST) etc.complete as per specification and direction of the Engineer-in-charge.