Tenders of Uranium Corporation Of India Limited in Jharkhand

Auction Sale Of Lot No : 1.0 Lot Name : End Of Life Vehicles ,

Tube Size,tube Size 12.00 X 24 Suitable For Underground Equipment,flap Size 12.00 X 24

CATEGORY: Polyester Webbing Slings (Q4)

Head Pully, 650 Dia Excluded: De & Nde Bearing & Bearing Blocks,tail Pulley, 650 Dia Excluded: De &

Stud Part No. 5536168800 As Per Drawing

CATEGORY: Liquid Crystal Display LCD Panel or Monitors (Q2)

Xerox Paper

Antiseptic Liquid (v2)

Supply Of Precoat Waste Tank As Per Drawing No: Uci/m-1014/c (moc-ss316l

BOQ ITEMS: Earth work in excavation by mechanical means Hydraulic excavator or manual means over areas exceeding 30 cm in depth 1.5 m in width as well as 10 sqm on plan including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5 m as directed by EIC., Excavation work by mechanical means Hydraulic excavator or manual means in foundation trenches or drains not exceeding 1.5m in width or 10 sqm on plan including dressing of sides and ramming of bottoms lift upto 1.5 m including getting out the excavated soil and disposal of surplus excavated soils as directed within a lead of 50 m. Ordinary rock, Return earth filling by available excavated earth excluding rock in trenches plinth sides of foundations etc. in layers not exceeding 20cm in depth consolidating each deposited layer by ramming allow for breading up lumes shrinkage etc watering lead upto 50 metre and lift up to 1.5m complete as directed by the E.I.C, Disposal of building rubbish or malba or similar unserviceable dismantled or waste materials by mechanical means including loading transporting unloading to approved municipal dumping ground or as approved by EIC beyond 50 m initial lead for all leads including all lifts involved., Clearing jungle including uproting of rank vegetation grass brush wood trees and saplings of girth upto 30 cm measured at a height of 1m above ground level and removal of rubbish upto a distance of 50m outside the periphery of the area cleared., Providing and laying plain cement concrete 1 isto 3 isto 6 one Cement isto three Coarse sand isto six graded stone aggregate 20mm nominal size. Note Material or Item must be approve to UCIL before supply/installation. , Providing and laying reinforced cement concrete work in walls any thickness including attachedpilasters buttresses plinth and string courses fillets columns piers aboutments posts and struts etc.Up to floor five level excluding cost of centering shuttring finishing and reinforcement.1 isto 1.5 isto 3 one cement isto one point five coarse sand isto three Graded stone aggregate 20mm nominal size. Note Material or Item must be approve to UCIL before supply or installation. , Reinforcement for RCC Work including straightening cutting bending placing in position and binding all complete.Hot rolled deformed base Note Material or Item must be approve to UCIL before supply or installation. , Centering shuttering including removal of form work for all types of work. for providing and fixing straight shuttering Foundation footings bases of columns etc., Brick work with FPS brick of class designation 75 in foundation and plinth in cement mortar 1 isto 6 one cement isto six coarse sand. Note Material or Item must be approve to UCIL before supply or installation. , Brick work with FPS brick of class designation 75 in superstructur and plinth in cement mortar 1 isto 6 one cement isto six coarse sand brick work in superstructure above floor V level .Note Material or Item must be approve to UCIL before supply or installation. , Structural steel work riveted, bolted or welded in built up sections trusses and framed work including cutting hoisting fixing in position and applying a priming coat of approved steel primer all complete. Note Material or Item must be approve to UCIL before supply or installation. , 15 mm cement plaster on rough side of single or half brick wall of mix 1 isto 6 one cement isto six coarse sand Note Material or Item must be approve to UCIL before supply or installation. , Providing and fixing water closet squatting pan Indian type W.C. pan with 100 mm sand cast Iron P or S trap 10 litre low level white PVC flushing cistern including flush pipe with manually controlled device handle lever conforming to IS 7231 with all fittings and fixtures complete including cutting and making good the walls and floors wherever required. White Vitreous china Orissa pattern W.C. pan of size 580 into 440 mm with integral type foot rests. Note Material or Item must be approve to UCIL before supply or installation. , Providing and fixing PVC low level flushing cistern with manually controlled device handle lever conforming to IS 7231 with all fittings and fixtures complete. 10 litre capacity White. Note Material or Item must be approve to UCIL before supply or installation. , Providing and fixing wash basin with C.I. brackets 15 mm C.P Brass pillar taps 32 mm CP brass waste of standard pattern including painting of fittings and brackets cutting and making good the walls wherever require White Vitreous China Wash basin size 630 into 450 mm with a single 15 mm CP brass pillar tap. Note Material or Item must be approve to UCIL before supply or installation. , Providing and fixing 100 mm sand cast Iron grating for gully trap. Note Material or Item must be approve to UCIL before supply or installation. , Providing and fixing mirror of superior glass of approved quality and of required shape and size with plastic moulded frame of approved make and shade with 6 mm thick hard board backing Rectangular shape 453 into 357 mm Note Material or Item must be approve to UCIL before supply or installation, Providing and fixing brass bib cock of approved quality 15 mm nominal bore. Note Material or Item must be approve to UCIL before supply or installation. , Providing and fixing G.I pipes complete with G.I fittings including trenching and refilling etc. 15 mm dia nominal bore. Note Material or Item must be approve to UCIL before supply or installation. , Providing and fixing G.I pipes complete with G.I fittings including trenching and refilling etc. 25 mm dia nominal bore. Note Material or Item must be approve to UCIL before supply or installation , Providing and fixing precoated galvanised iron profile sheets size shape and pitch of corrugation as approved by EIC 0.50 mm plus 0.05 percent total coated thickness with zinc coating 120 grams per sqm as per IS 277 in 240 mpa steel grade 5 to 7 microns epoxy primer on both side of the sheet and polyester top coat 15 to 18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by EIC. The sheet shall be fixed using self drilling or self tapping screws of size 5.5 into 55 mm with EPDM seal complete upto any pitch in horizontal or vertical or curved surfaces excluding the cost of purlins rafters and trusses and including cutting to size and shape wherever required. Corrugated sheet up to 60 pitch. Note Material or Item must be approve to UCIL before supply or installation , Providing and fixing precoated galvanised steel sheet roofing accessories 0.50 mm plus 0.05 percent total coated thickness Zinc coating 120 grams per sqm as per IS 277 in 240 mpa steel grade 5 to 7 microns epoxy primer on both side of the sheet and polyester top coat 15 to 18 microns using self drilling or self tapping screws complete Ridges plain 500 to 600mm. Note Material or Item must be approve to UCIL before supply or installation, Providing and fixing C.P brass bib cock of approved quality conforming to IS8931 15 mm nominal bore C.P Bib cock or piller cock. Note Material or Item must be approve to UCIL before supply or installation. , Providing and fixing C.P. brass angle valve for basin mixer and geyser points of approved quality conforming to IS8931 15mm nominal bore. Note Material or Item must be approve to UCIL before supply or installation. , Providing and fixing gun metal gate valve with C.I wheel of approved quality screwed end 25 mm nominal bore. Note Material or Item must be approve to UCIL before supply or installation, Providing and fixing aluminium extruded section body tubular type universal hydraulic door closer having brand logo with ISi IS 3564 embossed on the body door weight upto 36 kg to 80 kg and door width from 701 mm to 1000 mm with double speed adjustment with necessary accessories and screws etc. complete. Note Material or Item must be approve to UCIL before supply or installation. , Providing and fixing ISI marked M.S pressed butt hinges bright finished with necessary screws etc . Complete. 100 into 58 into 1.90. Note Material or Item must be approve to UCIL before supply or installation. , Providing and fixing ISI marked oxidised M.S sliding door bolts with nuts and screws etc Complete. 300 into 16 mm. Note Material or Item must be approve to UCIL before supply or installation. , Providing and fixing ISI marked oxidised M.S tower bolt black finish Barrel type with necessary screws etc complete. Size 150 into 10 mm. Note Material or Item must be approve to UCIL before supply or installation. , Providing and fixing ISI marked oxidised M.S handles conforming to IS 4992 with necessary screws etc completed . 125 mm. Note Material or Item must be approve to UCIL before supply or installation. , Providing 1.5 mm cement punning curing carriage of water with all leads and lifts as per building specification and direction of EIC. Note Material or Item must be approve to UCIL before supply or installation. , Supplying and applying two 2 or more coats of white wash over new work at various elevations including preparation of surfaces cleaning etc. complete with all materials labour tools and tackle etc. scaffolding work as per specifications and directions of EIC COMPOSITION Water at the rate 5 litres per Kg of lime for making cream. Fevicol DDl at the rate 4 gm. Per litre of lime cream. Robin Blue at the rate 2gm. Per Kg lime. New work three or more coats. Note Material or Item must be approve to UCIL before supply or installation. , Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade Two or more coats on new work over an under coat of suitable shade with ordinary paint of approved brand and manufacture. Note Material or Item must be approve to UCIL before supply or installation. , Finishing walls with Acrylic Smooth exterior paint of required shade New work Two or more coat applied at the rate 1.67 ltr per10 sqm over and including priming coat of exterior primer applied at the rate 2.20 kg or 10 sqm. Note Material or Item must be approve to UCIL before supply or installation. , Supplying and stacking at site 63 mm to 45 mm size stone aggregate. Note Material or Item must be approve to UCIL before supply or installation. , Supplying and stacking at site. Moorum. Note Material or Item must be approve to UCIL before supply or installation. , Laying spreading and compacting stone aggregate of specified sizes to WBM specifications in uniform thickness hand picking rolling with 3 wheeled road or vibratory roller 8 to10 tonne capacity in stages to proper grade and camber applying and brooming requisite type of screening or binding material to fill up interstices of coarse aggregate watering and compacting to the required density. Note Material or Item must be approve to UCIL before supply or installation. , Random rubble masonry with hard stone in foundation and plinth including levelling up with cement concrete 1 isto 6 isto 12 one cement isto six coarse sand isto twelve graded stone aggregate 20 mm nominal size at plinth level with cement mortar 1 isto 6 one cement isto six coarse sand. Note Material or Item must be approve to UCIL before supply or installation. , Removal of earth from the effulent drain and earth work in excavation by mechanical means Hydraulic excavator or manual means in foundation trenches or drains not exceeding 1.5 m in width or 10 sqm on plan including dressing of sides and ramming of bottoms lift upto 1.5 m including getting out the excavated soil and disposal of surplus excavated soil as directed beyond lead of 50 m.