Andhra Pradesh Medical Services And Infrastructure Development Corporation Tender

Supply Installation Testing & commissioning of free standing floor mounted dust and vermin proof compartmentalised cubical panel made out of CRCA sheet, required hardware, duly painted by two coats of zinc/red oxide primer followed by Powder coated/epoxy/PU painted with phosphatisation in grey or required shade after rinsing. The panel having PU/Neoprene rubber gasket of not less than 3mm thickness,separate detachable, gland plate M.S. base channel, hinged door with locking arrangement for equipment/ switchgear. Thickness of sheet shall not be less than 1.6mm up to 600mm length/width of any compartment and be of 2.0mm above 600mm. Load bearing structure shall be of 2.0mm thick sheet supported by base M.S. channel if required. Side walls and cable alley compartments having bolted type doors with detachable extension type structure, with proper ventilation arrangements for power capacitors with ventilating fans and louvres for natural cooling with required size of G.I. earth bus bar etc., complete. (Panel shall be fabricated from reputed and branded manufacturers approved by dept and having CPRI approval with CPRI test certificates). Incomer :- 250A Four Pole, MCCB of adjustable, confirms to IEC 60947-2 and IS 13947-Part 1&2 having Breaking Capacity 35/36 KA with thermal magnetic release Panel Mounted - 1 No. Makes: L&T- D shine / Schneider-NS NSX/Legrand -DP X3/ Siemens-3VL Outgoing feeders:- Supply of 125A, 3 Pole, Adjustable, Confirms to IEC 60947-2 and IS 13947-Part 1&2 having Breaking Capacity 25 KA with thermal magnetic release Panel Mounted - 5 No. Makes: L&T- D shine / Schneider-NS NSX/Legrand -DP X3/ Siemens-3VL Supply of 63A/60A, 3 Pole, Adjustable, Confirms to IEC 60947-2 and IS 13947-Part 1&2 having Breaking Capacity 16 KA with thermal magnetic release Panel Mounted - 3 No. Makes: L&T- D shine / Schneider-NS NSX/Legrand -DP X3/ Siemens-3VL Supply Installation Testing and commissioning of self healing MPP/MP type shunt capacitor (banks) conforming to IS:13340-41 / IEC :831-1&2 in existing panel or parallel with load terminals , the capacitor shall be fitted with discharge resistors, pressure sensitive disconnector (PSD) and shall have dissipation factor less than 0.0025 at 50 Hz and total wattage loss less than 0.5 Watt per KVAR. including making connections with suitable capacity conductors/ cables testing as required, Heavy duty Three phase 440 V , 50 Hz capacitor (Bank) of 150 KVAR. Makes: L&T/Seimens/Epcos/ Schneider/ Havells Supply and Fixing of 440 Volt 3 pole capacitor (AC 6 B ) duty contactor with 3 no. early make and post break auxiliary contacts in series with quick discharge damping resistors/ reactors to limit the inrush current ,conforming to IS:13947-4-1/IEC:947-4-1, Din rail mounting type ncluding making onnections, testing etc. as required suitable for 7 to 10 KVAR capacity capacitor bank - 3 No. Make:Seimens/ABB/Schneider/L&T/C&S/HPL/Havells Supply Installation Testing and commissioning of microprocessor based intelligent power factor correction relay having sensitivity up to 50 milli Amp secondary current and following way, self analysing auto c/k setting according to targeted power factor setting, the relay shall have minimum three digit display unit for display of real power factor, targeted power factor, lag/lead capacitor switching status, alarm output for under current, over current, insufficient compensation, indication of switching on units, auto/manual status, and shall have over load protection, no volt release etc. as required, 6 to 14 stage - sensitivity upto 50 milli Amp - 1 No. Makes: L&T/Seimens/Epcos /Schneider/ ABB/Neptune Bus Bars:- Supply and fixing of Electrolytic grade aluminium bus bars by means of SMC / DMC type insulator, high tensile nuts and bolts spring washers in existing panel including bending , cutting in required shape and size and colour coding with heat shrinkable PVC sleeves For Main Bus Bars vertical & horizontal, Phases & Neutral equal sizes of 40mm x 10mm x 4R and for sectional bus bars and extended links to MCCBs shall be more than or equal to the ratings of MCCBs/ACBs Control wiring with suitable size of approved make FRLS PVC flexible copper wires, Earth Bus Bar, Door Loop earhtings, Ferrules, Feeder identifications, danger plate, door locks, auxilary contactors for auto manual operation and all other accessories, ventilating fans for the Capacitors and including all labour charges etc with connections for finished item of work including transportation charges

Supply Installation Testing And commissioning of 125 KVA DG Set complete with 1500 RPM Diesel Engine of suitableBHP & AC Brush less SPDP Alternator mounted on a common base Frame & coupled through a flexible coupling or close coupled.Alternator: It shall be self regulated, self excited and confirms to IS: 13364/1992 or latest version with regulation of +5% from No load to full load, IP23, with standard Alternator Protection( Over voltage, over speed & under voltage). DieselEngine: Itshall have residential silencer, up to 10 M exhaust piping , electronic / Mechanical governor, Manual & electric Start, Batteries, Fuel tank & piping, control panel (16 G) with SPN(For 5 KVA)/TPN MCCB of required rating (25/36/50 KA) with PLC based Engine controller supplied by OEM, Ammeter, Voltmeter, Frequency Meter or Multi function meter, Energy Meter & Hour Meter, Engine instruments anel,AVM and Automatic Voltage Regulator. The diesel engine shall be capable of providing 10% over load for 1 Hr for every 11 Hrs of continuious running at full load.The DG set shall be supplied with initial filling of fuel,lube oil, coolant oil as per OEM specifications and shall be tested at site.Accoustic Enclosure: Weatherproof, powder coated Accoustic enclosure for DG set for sound attenuation fabricated from 1.6 mm CRCA sheet steel (structure) with side wall fabricated from 1.6 mm CRCA sheet and filled with foam as per CPCB norms latest amendments & IS 8183 .The doors are fabricated from 1.6 mm CRCA sheet packed with accoustic material, floor of MS chequrred plate 5.0 mmthick, All doors/ opening are sealed with neoprene/ EPDN gaskets.The DG Set shall be maintained for two years after commissioning by the supplier including regular servicing, cost of consumables etc complete as specified by the OEM along with warranty for two years. Makes: Cummins/Koel Green/Greaves Alternator Make: Stamford/ Kirloskar/ CromptonGreaves/Leroysomer Supply and Fixing of 440 Volt 3 pole capacitor (AC 6 B ) duty contactor with 3 no. early make and post break auxiliary contacts in series with quick discharge damping resistors/ reactors to limit the inrush current ,conforming to IS:13947-4-1/IEC:947-4-1, Din rail mounting type ncluding making onnections, testing etc. as required suitable for 11 to 20 KVAR capacity capacitor bank - 3 No. Make:Seimens/ABB/Schneider/L&T/C&S/HPL/Havells Supply and Fixing of 440 Volt 3 pole capacitor (AC 6 B ) duty contactor with 3 no. early make and post break auxiliary contacts in series with quick discharge damping resistors/ reactors to limit the inrush current ,conforming to IS:13947-4-1/IEC:947-4-1, Din rail mounting type ncluding making onnections, testing etc. as required suitable for 30 KVAR capacity capacitor bank - 2 No. Make:Seimens/ABB/Schneider/L&T/C&S/HPL/Havells Metering:- Supply and Fixing of (0-500) V range Volt meter on existing panel, making connection by PVC insulated copper conductor with PVC sleeves/channel etc., as required. - 1 No. Make:Conzerve/Elmeasure/ Meco/ HPL/L&T/ Socomec Supply and Fixing of CT operated direct reading type Ammeter, below 500A, on existing panel , making connection by PVC insulated copper conductor with PVC sleeves/channel etc. as required - 1 No. Make: Conzerve/Elmeasure/Meco/HPL/ L&T/ Schneider/AE/ Socomec Supply and Fixing of Current Transformer, from 200 / 5 to 400/5 Ratio , 15 VA , class 1 accuracy with all necessary support in existing panel including connection etc. as required - 3 Nos. Make: Kappa/L&T/ Seimens/ C&S/ Schneider Supply and Fixing of 240/220 V, LED (22.5 mm dia) Pilot lamp Red & Yellow, Green Colour with integral circuit, terminal block, including connection etc. as required for capacitor ON and OFF + Supply indication - 18 No of approved make Supply and Fixing of 240/220 V, LED (22.5 mm dia) Pilot lamp Blue Colour with integral circuit, terminal block, including connection etc. as required for supply indication - 1 No of approved make Supply and Fixing of selector switch for voltmeter (4 position) including making connection etc. as required - 1 No. Make: L&T / C&S/ Salzer/HPL Supply and Fixing of CT linked selector switch of 10 A for Ampere meter (4 position) including making connection etc. as required. - 1 No. Make: L&T/C&S/Salzer/ HPL Supply and Fixing of Cam operated rotary switches on existing panel with 2 way and off position, one pole, 32A. (auto mannual selector switch for capacitors) - 8 No. Makes: L&T (SALZER)/ABB/ Schneider/ Seimens /C&S/HPL. Supply and Fixing of Non-Luminious type, push button actuators and integral contact block of dia. 22.5 mm including making connection etc. as required - 16 No. Make:Seimens/ ABB/ Schneider/ L&T/ C&S/HPL 10 kA - 6-32A range SP MCBs - 6 No. Make: Legrand-DX3 / Schneider-Acti9/Hager-h3/ Siemens-5SX4/ Crabtree-Xpro/L&T-AU

Supply Installation Testing and Commissioning of AUTO MAINS FAILURE (AMF) Panel with IP 52 protection, fabricated from CRCA sheet steel 2mmThick , Powder coated finish , Engine START & STOP commands,control RELAYS, selector switches for Ammeter & Voltmeter, Ammeter & Voltmeter ,4pole MCCBs for EB Supply and DG Supply of required rating and breaking capacity,Automatic battery charger (External charger for DG) Control & Power Contactors, Timers, Electronic Hooter ,Visual & Alarm indication for faults, UPS, operator interface panel complete in all respect suitable for 125KVA capacity DG set