No hidden charges. No keyword restrictions.Join free for a month

Page 1 of 14 ( Signature, Seal & Stamp of the Bidder ) CENTRAL CONTRACTING CELL, MM DEPARTMENT, BHEL, JHANSI GENERAL TERMS AND CONDITIONS OF ENQUIRY JHS 2055B R01 SN Description I General: A These general terms & conditions shall apply to all enquiries, notice inviting tenders, request for quotations for Labour Supply Contracts and / or rendering of Works Contracts to Bharat Heavy Electricals Ltd., Jhansi ( hereinafter referred to as BHEL ) for its requirements . B Special / supplementary enquiry conditions, & Checklist requirements, if any, covered in the respective enquiry, will override the relevant conditions mentioned in this document C Commercial Conditions quoted by the vendor in any place including as stated in bidder's ‘General Terms and Conditions’ if any, shall not be binding on BHEL. Only the conditions contained in this document, including special conditions, if any, for this enquiry shall prevail. D The details of Notice Inviting Tender (NIT), Work Specification, and associated Qualifying Requirements are enclosed separately to the respective enquiry II Instructions to Bidders A Sealed bids are invited for scope of Supply of Labour / Works, as detailed in the enquiry. Bid should be free from correction, overwriting, using corrective fluid, etc. Any interlineation, correction, erasure, or overwriting shall be valid only if they are attested under full signatures of person(s) signing the bid , else bid shall be liable for rejection. Any overwriting / cutting, etc. will be numbered by bid opening officials and announced during bid opening. Relevant enclosures, supporting documents, catalogue, samples, if any, as required as per Notice Inviting Tender (NIT) conditions shall be sent along with technical offer. All the columns in the tender form should be filled without leaving blank in any page of the tender and all the pages must be duly signed & stamped by the bidders before submission. Price quoted should be as per Price Bid Format, as applicable ( Excel Sheet - Form JS 145 for labour contracts / Form JS 146 for Works Contracts ) enclosed as soft copies to the Enquiry. Bidder to fill the same as called for in the respective form ( Excel Sheet enclosed to the NIT) , take a print, and submit the Price Bid with seal and stamp. If Price is quoted in any other format other than the Excel Sheet enclosed to the NIT , the offer of the bidder will be rejected. Rate should be quoted in the units asked for in the enquiry. The rates should be quoted in figures in the unlocked cell of the excel sheet, and a provision is made in the excel sheet to derive the corresponding value in words. B In case of non-conformities / errors / discrepancies are observed between the quoted prices in figures and that in words, following guidelines are to be followed:- (i) In the price structure quoted, if there is discrepancy between the unit price and the total price (which is obtained by multiplying the unit price by the quantity), the unit price shall prevail and the total price corrected accordingly, unless in the opinion of the tenderer, there is an obvious misplacement of the decimal point in the unit price, in which case the total price as quoted shall be governed and the unit price corrected accordingly. (ii) If there is an error in a total corresponding to the addition or subtraction of subtotals, the subtotals shall prevail and the total shall be corrected. (iii) If there is a discrepancy between words and figures, the amount in words shall prevail, unless the amount expressed in words is related to an arithmetic error, in which case the amount in figures shall prevail subject of (i) and (ii) above. (iv) If there is such discrepancy in an offer, the same shall be conveyed to the bidder with target date up to which the bidder has to send his acceptance on the above lines and if the bidder does not agree to the decision of the tenderer, the bid is l

Disclaimer: Bidassist has made every reasonable effort to ensure that the information is accurate and authentic however it cannot be held liable for any third-party claims or losses of any damages. Bidassist makes no warranty, expressed or implied, as to the results obtained from the use of the information. If you think you may have noticed any error or omission, please let us know by contacting contact@bidassist.com.